Fixed a particular case of single groove where the ID groove was starting and ending at the Z axis instead of the clearance plane #10422.
Fixed a bug with a particular single groove case where an ID groove was not cutting upto the outer radius #10423.
Fixed the issue where an inside threading operation in turning was allowed to end at the final toolpath Z position (unsafe) instead of at the safe Z position #10386.
Fixed an issue where a Turning Part operation was not generating the correct toolpath when edge break was turned on and a round grooving tool was used #10672.
Fixed an issue where expressions did not persist in the Chuck Offset field in a turning / mill turn setup dialog #10694.
Fixed potentially wrong initial tool axis for multi-axis toolpath for stock simulation.
Updated simulation to avoid some annoying false reports of collisions for multi-axis toolpath.
Improved radius compensation for 2D Profile operations in various examples #9736.
Removed unused 'fineStepdown' parameter from 3d Contour & 3d Pocket operations #10291.
Added turret column to tool library #10554.
Added the ability to set the Safe Z in the setup dialog with reference to the WCS origin, stock front or stock back #8661.
Added the ability to override the Safe Z from the setup dialog in each turning operation and specify an approach and retract point #10199.
Added the ability to round sharp corners in a parting toolpath, specifically when edge break with a chamfer is enabled.